Filter
Top Products
PAGE42 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)
MAINTENANCE
Fuel Filter (500 Hours)
Replace the engine fuel filter (Figure 42) every 500 hours.
Refer to your engine manual for specific details to perform
this operation.
Oil And Fuel Lines
Check the oil and fuel lines and connections regularly for
leaks or damage. Repair or replace as necessary.
Engine Tune-Up
See your engine manual for specific information on tuning
up your engine.
At the front of the book, there is a “Daily Pre-Operation
Checklist.” Make copies of this checklist and use it on a
daily basis.
Disconnect negative (ground) battery cable and secure away
before attempting any service or maintenance on the saw.
Figure 42. Fuel Filter Removal
1
See the engine manual supplied with your
machine for appropriate engine maintenance
schedule and troubleshooting guide for
problems.
LUBRICATION
This saw has many service-saving features, including fully
enclosed oil bath lubricated blade shaft bearings that require
no daily lubrication.
This saw has 4 grease fittings on the front axle assembly.
See Figure 43.
Grease these fittings every 125 hours of operation with a
premium grade waterproof E.P. (extreme pressure) grease.
WARNING — Crush Injury
Prevent Crush Injury!
Ensure the saw is securely placed on
blocks before servicing lubrication points.
1. Front Axle Pivot Bearing
2. Hydraulic Lift Cylinder End
Figure 43. Grease Fittings