Filter
Top Products
SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09) — PAGE 31
STAY-LEVEL HANDLEBARS/BATTERY
STAY-LEVEL HANDLEBARS (SLH)
This saw incorporates a unique handlebar design that allows
the handlebars to maintain a level height position regardless
of the angle of the saw. Along with this, the height of the
handlebars can be adjusted for individual operator providing
for more comfortable operation.
To adjust the handlebar height:
1. Loosen the SLH linkage adjustment plate bolts (Figure 21).
2. Set the handlebars to the desired height.
3. Tighten the SLH linkage adjustment plate bolts.
BATTERY SETUP
Figure 21. Stay-Level Handlebars
WARNING — Battery hazards
Always recharge the battery in a well-
ventilated area to avoid risk of a dangerous
concentration of combustible gases.
Battery electrolyte contains corrosive,
toxic chemical. (dilute sulfuric acid). Avoid
contact with eyes and skin.
WARNING — Shock hazards
Disconnect battery cables before inspecting
electrical system and never “spark” battery
terminals to test for charge.
CAUTION — Battery safety
Use all safety precautions specified by the battery
manufacturer when working with the battery.
This saw was shipped with a wet charged battery (Figure 22).
This battery may need to be charged for a brief period of time
as per the manufacturer instructions.
To install the battery on the saw, make sure that the battery is
properly clamped into the battery box. Connect the positive
cables to the positive terminals on the battery first, then connect
the negative cables to the negative terminals.
Figure 22. Battery and Battery Box
The 7060 uses two positive battery cables and
two negative battery cables. One set is for engine
start, and the other is for the raise/lower pump
assembly. Make sure that both sets of cables are
connected to the battery. Also, LIMIT the cycling
of the raise/lower system on battery power only.
Frequent cycling will diminish the life of the battery.