Multiquip SP706030 Chainsaw User Manual


 
PAGE22 — SP7060 PAVEMENT SAW • OPERATION MANUAL — REV. #0 (02/13/09)
BASIC ENGINE INFORMATION
Figure 6. Basic Engine Components
17
7
9
10
13
16
5
6
12
14
8
4
1
3
11
2
18
15
BASIC ENGINE COMPONENTS
The following refers to basic engine components and their
functions that an operator may need to reference. The
manufacturer’s engine manual provides further instructions
and details of operation and servicing. The engine shown
in Figure 6 is a Deutz BF3L2011 engine.
1. Fuel Filter — Removes dirt and water from the engine
fuel.
2. Governor Lever — This lever restricts engine speed
(high idle and low idle) through a speed control device
linked to the accelerator system.
3. Oil Dip Stick — Remove to check amount and condition
of oil in crankcase.
4. Oil Filter — Spin-on type, filters oil for contaminants.
5. Oil Drain Plug and Hose — Remove plug and attach
drain hose to drain crankcase oil.
6. Oil Filler Port — Remove to add fresh crankcase oil.
7. Crankshaft V-Pulley — Check fan V-belt between V-Pulley
and fan to determine proper belt tension.
8. Cooling Fan — Driven by the V-belt, the cooling fan cools
the engine by cooling engine oil that circulates through
the engine block and cylinder head.
9. V-belt Tension Adjustment — This bolt provides means
to adjust the V-belt tension at the alternator bracket.
10. V-belt (Fan belt) — Driven by the engine crank during
operation, drives the fan as well as the aternator.
11. Oil Fill Cap — Remove to add engine oil.
12. Lifting Eye — The lifting eye is provided if the removal/
installation of the engine becomes necessary.
13. Alternator — Located inside the fan assembly. Provides
current to the electrical system and charges the battery.
Driven by means of a crankshaft/V-belt pulley system.
14. Starter — Starts engine when ignition key is rotated to
the “START” position.
15. Flywheel — Main power is taken off from the flywheel
end.
16. Air Intake Port — Provides air from the air cleaner to the
turbocharger unit.
17. Turbocharger — Provides pressurized intake air to the
cylinder by means of a turbine energized by exhaust gas
that rotates the blower.
18. Air Cleaner Assembly — Provides clean filtered air to
the air intake port.