Filter
Top Products
7
Section 1 Assembly and Set-Up
03/11/03
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
Land Pride
Section 1
Assembly and Set-Up
Control Lever and Seat Assembly
The seat is removed for ease in shipping and the control
lever’s upper bolts and flat washers are removed and the
levers are rotated down.
Refer to Figure 1-1:
1. Install the standard seat (#1) (or the optional
suspension seat) to the seat pan (#2) using four 5/16”
nuts (#3) and four 5/16” flat washers (#4).
2. Connectthe switch wireson the mower with the switch
wires on the seat. Secure the switch wires to the seat
pan (#2) using three wire ties (#5).
3. Flipthe seat overinto the operating position and rotate
the control levers up untilthe holes lineup and replace
the bolts and flat washers.
Remote Air Cleaner Assembly
Refer to Figure 1-2:
1. Slide air cleaner clamp (#1) over air cleaner housing
(#2), position the clamp so the bolt holes are facing
down (away from the intake) and the notches on the
clamp fit in the notches on the housing.
2. Insert air cleaner element (#3) inside air cleaner
housing (#2) and attach housing end (#4) (with the
arrows pointing up). Place rubber grommet (#5) over
opening in housing end (#4).
3. Attach air cleaner intake cap (#6) to the air cleaner
housing (#2) using a hose clamp (#7).
4. Attach air cleaner hose (#8) to the air cleaner (#2)
using a hose clamp (#7).
Refer To Figure 1-3:
5. Remove plastic cap from carburetor intake.
!
CAUTION!
Be careful to not allow any foreign material into the carburetor
while performing this assembly.
Seat Assembly
Figure 1-1
20858
Carburetor Intake
Figure 1-3
20859
Plastic Cap
Air Cleaner Assembly
Figure 1-2
20862