Filter
Top Products
14
Section 2 Operation
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03
Land Pride
Left/Right Fuel Tank Valve
Refer to Figure 2-3:
The mower is equipped with a Left/Right Fuel Tank Valve
that will determine which fuel tank the mower is operating
from. Itis not important which fuel tankthe mower is using.
Blade Engagement Switch
Refer to Figure 2-2:
This switchengages thedeck blades. Pull theswitch up to
engage and push switch down to disengage the clutch.
Control Levers
Parking Brake
The Parking Brakes are applied by moving the control
levers from theNeutral Position(Figure 2-5)to anoutward
position (Refer to Figure 2-4). Each rear wheel brake
operates independently of the other.
!
WARNING!
In the event of a system failure while mowing, engage both
parking brakes to stop or slow mower. Refer to Figure 2-4.
Refer to Figure 2-5:
These levers controlthe mower’sspeed, direction, neutral
lock and park brake. Levers are used to steer, accelerate,
brake and change direction. The mower will not move
when the engine is on, drive pumps are operating and the
control levers are in the park brake position (out)
Figure 2-4.
!
WARNING!
The parking brake is not designed to hold the mower on steep
slopes.
Deck Lift Pedal
Refer to Figure 2-6:
The deck lift pedalis used to raise or lower the deck. Push
on the pedal to raise the deck and then place the deck
height locking pin into the desired cutting height hole.
Push the deck lift pedal to raise the deck when going over
obstructions.
Left/Right Fuel Tank Switch
Figure 2-3
IMPORTANT: Never engage clutch with engine
running at high rpm or when the deck is under load.
Clutch, belts or deck could be damaged.
Control Levers in Parking Brake Position
Figure 2-4
19698
Control Levers
Figure 2-5
Control Levers
19060
Deck Lift
Pedal
Deck Lift Pedal
Figure 2-6
19061
Deck Height
Locking Pin