Filter
Top Products
21
Section 4: Maintenance and Lubrication
6/26/06
RCS3596, RCSM3596, RCS3510 & RCSM3510 Series Rotary Cutters 312-708M
Land Pride
Table of Contents
Lubrication
Tailwheel Spindle Tube
Lift-Type Cutter
Type of Lubrication: Grease
Quantity = 6 pumps
Tailwheel Hub
The tailwheel hub is equipped with a relief hole located
directly opposite the grease fitting. The relief hole
releases pressure from inside the hub casting when it
is greased. The hub should be greased until grease
purges from the relief hole.
Type of Lubrication: Multi-purpose Grease
Quantity = Until grease purges from the relief hole
Gearbox & T-Box
Check oil level in the gearbox by removing the side plug in
the gearbox case. If the oil level is low, remove the top plug
in the gearbox case and fill with EP90 oil until oil flows from
the side port of gearbox case. Reinstall plugs and tighten.
Type of Lubrication: EP90 Oil
Quantity = Fill until oil flows from the side port of gearbox
case.
NOTE: Do not overfill! Cutter should be level when
checking oil.
20701
20701
20701
24
Hours
8
Hours
8
Hours
50
Multi-purpose
spray lube
Multi-purpose
grease lube
Intervals in hours
at which lubrication
is required
Lubrication
Legend
Multi-purpose
oil lube