Filter
Top Products
11
Section 1: Assembly and Set-Up
6/26/06
RCS3596, RCSM3596, RCS3510 & RCSM3510 Series Rotary Cutters 312-708M
Land Pride
Table of Contents
Safety Guards (Optional)
!
DANGER!
Rotary Cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety guards is
strongly recommended when cutting along highways or in an
area where people may be present.
Front Chain Guards
Refer to Figure 1-3
Install the left hand (#2) and right hand (#1) front chain
guards with carriage bolts (#3), and flange nuts (#4). The
narrow end of the chain guards goes to the outside.
RCS3596 is shown. The RCS3510 has a center chain
guard that will assemble between the left hand and right
hand chain guards.
Front Chain Guard
Figure 1-3
Rear Chain Guards
Refer to Figure 1-4
Install the rear chain guard (#1) with 1/2” -13 x 1 1/2” long
carriage bolts (#2), and 1/2” flange nuts (#3).
Rear Chain Guard
Figure 1-4
NOTE: Do not tighten hardware until assemblies
are complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 28.
20704
20705
Front Rubber Guards
Refer to Figure 1-5:
Install each guard of the front rubber guards (#1) with the
carriage bolts (#2) and flange nuts (#3). RCS3596 is
shown. The RCS3510 has a center rubber guard that
will assemble between the left hand and right hand
rubber guards.
Front Rubber Guards (RCS3596 Shown)
Figure 1-5
Rear Rubber Guards
Refer to Figure 1-6
Install the rear rubber guard (#1) and rear guard strap
(#2) with the carriage bolts (#3) and flange nuts (#4).
Rear Rubber Guard
Figure 1-6
20706
20711