Filter
Top Products
22
Section 4: Adjustments
RCP2560 & RCPM2560 Series Parallel Arm Rotary Cutter 316-057M
4/28/08
Land Pride
Table of Contents
Deck Level Adjustments
The cutter deck should be adjusted for level attitude.
Adjust the cutter head deck cylinder (using the tractor
or optional electric cylinder control) so that the deck is
approximately level from left to right.
5. Raise the 3-Point hitch until the PTO shaft is
approximately level. Extend the parallel arms to full
length.
6. Place a level on the cutter deck to read forward/aft
attitude.
7. Adjust the 3-Point top link so that the front of the
cutter deck is slightly lower than the rear
(approximately 1/2"). See Figure 4-1
Section 4: Adjustments
Deck level Adjustments
Figure 4-1
12264