Filter
Top Products
21
Section 4 Maintenance and Lubrication
7/18/08
DM35 Series (S/N253045+) Disc Mowers 309-502M
Land Pride
Table of Contents
Cutter Bar
Check oil level in the cutter bar by removing the filler level
plug. With cutter bar in transport position, use a 5/16” or
8mm allen wrench to remove plug. (The plug is located
between the first and second discs on DM3506 and between
the second and third discs on DM3507.) If the oil level is low,
add oil.
Type of Lubrication: SAE 80 GL4 (EP) gear lube
Quantity =fill until level with in filler level plug hole.
NOTE: Do not overfill. Mower should be level and
cutter bar vertical when checking oil. Be sure to let
cutting bar set in vertical position for a few minutes
before checking to allow time for oil to flow to the
bottom of bar.
As
Required
Frame Pivot Point
Type of Lubrication: Grease
20
15154
17897
Hitch Pivot Point
Type of Lubrication: Grease
20
17897