Filter
Top Products
Assembly 37
5WPMAN0862 (11/22/2010)
Hydraulic Latch Release Installation
Figure 31. Hydraulic Latch Release Installation
1. Remove four 1/3 NC x 2 hex head cap screws and
1/2” flat washers from top of shield on trailer.
2. Attach item 1 on top of shield using hardware
previously removed.
3. Attach item 2 to wing release lever using items 10
and 11.
4. Attach base end of cylinder (3) to item 1 using
items 7, 8, and 9. Cylinder ports should be pointing
upward.
5. Attach rod end of cylinder (3) to item 2 using items
7, 8, and 9.
6. Install reducers (4), elbows (5), and hoses to base
of cylinder.
1. Release Base
2. Slide Channel
3. 3 x 8 Hydraulic Cylinder
4. Bushing
5. Elbow
6. Hose, 108”
7. Pin 1 x 4.08
8. Cotter Pin
9. Flat Washer, 1”
10. 3/8 NC x 1 HHCS GR5
11. 3/8 NC Flange Lock Nut