Filter
Top Products
Assembly 35
5WPMAN0862 (11/22/2010)
Attach the mower hydraulic hose to the tractor port.
Hydraulic quick coupler is not supplied.
NOTE: The mower hydraulic system should have been
filled at the factory. Always assume it is empty. Fully
purge air and fill the hydraulic system by raising and
lowering wings several times while hooked to a tractor
hydraulic supply. Keep all personnel away while raising
and lowering.
OPTIONAL EQUIPMENT
Light Kit Installation
Figure 27. Light Kit Installation
1. Install wire harness (5) to bracket on trailer frame
using #10 screws (10).
2. Route wires as shown. Be sure wire labeled “Left”
is routed to the left side of the unit. Wrap excess
wire around rear deck frame tubes as shown.
3. Clamp brackets (3) to rear deck frame tubes using
blanks (4), 3/8 bolts (6) and nuts (7).
4. Secure left and right lamp (1 & 2) to brackets using
1/4 bolts (8) and nuts (9).
5. Connect light to wiring harness.
6. Pull any slack out of main wire and install cable ties
(11) to rear hydraulic hose and trailer frame.
7. Extra slack in the light wires should be located near
the wireing harness. Make sure wires cannot
become entangled in driveline or hydraulic
cylinder. Secure wires to frame tubes above
cylinder and lock with cable ties.
Rear Roller Kit Installation
Figure 28. Rear Roller Kit Installation
1. Light, 4 Pin Right
2. Light, 4 Pin Left
3. Light Bracket
4. Blank .16 x 4.00 x 4.00
5. Wire Harness
6. 3/8 NC x 3-1/2 HHCS
7. 3/8 NC Flange Lock Nut
8.1/4 NC x 1 HHCS
9. 1/4 NC Lock Nut
10. #10 x 1/2 Tapping
Screw
11. 34” Cable Tie
1. Rear Roller
2. Rear Roller Bracket
3. 1/2 NC x 5-1/2 HHCS
4. 1/2 Flat Washer
5. 1/2 NC Flange Lock Nut
6. 3/8 NC x 1 Carriage Bolt
7. 3/8 NC Flange Lock Nut