Filter
Top Products
1. Make sure electric power is OFF at main breaker.
2. Static test water supply hoses for leaks.
3. Plug power cord into GFCI protected wall outlet.
4. Move the assembled J-Dream II into final position.
5. Connect 2" shower drain (see page 9).
6. Adjust the levelling screws in the J-Dream II base feet and lock them in position.
7. Recheck fit of drain plumbing.
8. Secure J-Dream II in position using clamps provided as shown in Figure 1.
9. Connect showerhead hoses to wall outlets, snap drain cover into place.
10. Adjust the Optica mixer rotational limit stop. To adjust, consult the Optica instructions enclosed with this manual.
23
J-Dream II Owner's Manual
Adjustable foot
Floor clamp
Lag bolt
Secure J-Dream II in position on
floor using clamps (provided) on
two front feet.
Velcro
®
FIGURE 1