Filter
Top Products
9
Drain Fitting (provided with unit)
Leave enough flexibility in the waste line to allow the end of the stub-out to be blocked temporarily in a position under flush
with the floor surface. This will allow the shower unit to slide across the floor into position without having to lift the shower
unit.
Remove the block and pull the drain assembly up to insert the stub into the drain. The drain fitting is a non-caulk
type (compression fitting) drain. Make certain that the locking ring is loose to allow the drain stub to insert easily inside
the rubber compression sleeve. If necessary, lubricate the sleeve with a mild soap solution. The drain stub must extend
well into the rubber sleeve before the locking ring is tightened. Use a screwdriver and the assembly tool provided to
tighten the locking ring.
J-Dream II Owner's Manual
Studwall
Drain
Compression
Fitting
Temporary
Wood Block
Drain Assembly
Floor
Broken Line
Represents
Drain Stub
Assembly Tool
Locking
Ring
Rubber
Compression
Sleeve
Screwdriver
Tighten
Locking Ring
Clockwise