Filter
Top Products
Page 73
J-400 Series
15.4 Ozone Water Maintenance System (Optional)
This system is optional on North American models and standard
equipment on export 50 Hz modes. If you spa is equipped with the
Jacuzzi CD ozone water purication system you will nd that your water
stays fresh and clear with signicantly less chemical usage. You will
probably be able to go longer between complete spa drainings.
Note: To maximize sanitation benets from this product, always turn off
the spa waterfall valve when the spa is covered or not in use. This setting
ensures maximum water ow through the ozone injector and higher
ozone concentrations. The ozone only runs when the circulation pump is
running and shuts off when either jets pump is manually activated during
spa use. The circulation pump will remain off for 5 minutes after both jets
pumps time out or are manually turned off, then resume operation as
programmed.
16.0 Error/Display Messages
There are a number of unique functions designed into your Jacuzzi spa
to protect it from damage and/or to aid in troubleshooting. When an error
occurs the spa will notify you by showing the screen below and an error
code next to it. Following is a listing of all the possible messages along
with their meanings:
1.
Overheat protection: (Heater is deactivated, lter/circulation pump is
activated). Water temperature is above acceptable limits. DO NOT
ENTER THE WATER! Remove spa cover to speed cooling. See
“Water Is Too Hot” on page 78. If condition persists, contact your
authorized dealer or authorized service center.
2. Water is below set-temp: If the spa water is more than 20 °F/6 °C
cooler than the temperature set point, the circulation pump and
heater will automatically activate to provide freeze protection. The
spa will stay in this mode until the water temperature reaches
15 degrees below the set temperature. No corrective action is
necessary.
98
F
Temp.
4:05 PM
!
“Displays
Error
Message”
WARNING: RISK OF HYPERTHERMIA (OVER-HEATING)
!