Support User Manuals

Invacare IH6300 Hot Tub User Manual

Open as PDF

of 32

SECTION 4—INSTALLATION

Supine Bath Tub 18 Part No 1096926

Securing the Tub

NOTE:Forthisprocedure,refertoFIGURE 4.1onpage 17andFIGURE 4.2.

1. Setthetubinplace.

2. Marklocationofanchorholes,usingpre‐drilledholesinlegmountingpadsasa

template(Detail“A” ofFIGURE 4.1).

3. Movetubawayfrommountingarea.

ƽ WARNING

Protective eye wear MUST be worn when drilling to avoid possible eye injury.

4. Drillanchorholesinfloor.Useajack‐drillwithacarbidebitforconcretefloorsora

woodbitforwoodfloors.

5. Repositionthetubinmountingarea,aligningtheholesinthelegmountingpadswith

theholesdrilledinSTEP4.

ƽ WARNING

DO NOT adjust height of legs more than 1 inch (25.4 mm); leg will disassemble

from leg mounting pad and serious injury may occur.

6. Levelthetubbyadjustingthetelescopiclegseitherupordown,usingawrench,to

achievethedesiredheight.

7. Checktomakesuretubislevelbyplacingalevelonthefrontandsidesofthetub

(Detail“A ”ofFIGURE 4.2).

8. RepeatSTEPS6and7untiltubislevel.

9. Securelegstofloorusingfastenersappropriateforthefloormaterialandinkeeping

withlocalcodes(Detail“B”ofFIGURE 4.2).

FIGURE 4.2 Securing the Tub

DETAIL “A” - LEVELING

Level

Level

Leg

Leg Mounting

Pad

Anchor

1-inch (25.4 mm)

Maximum Adjustment

DETAIL “B” - SECURING TUB

Lag Bolt

Leveling

End to End

Leveling

Side to Side

Lag Bolt

Anchor

previous next