Support User Manuals

Invacare IH6300 Hot Tub User Manual

Open as PDF

of 32

SECTION 3—OPERATION

Part No 1096926 15 Supine Bath Tub

Operating Shower/Massage Wand

NOTE:STEPS 1‐3areto beperformedwhileholdingthe shower/massagewandoverthetub.Referto

Featuresonpage 8for additionalillustrations.

1. Turnshower/massagewandontodesiredflowbyrotatingknob.

2. Adjustwatertemperaturewhilewatchingthermometer.

3. Adjustshowerspraybyrotatingshowerwandhead.

NOTE:Refer tothefollowingchartforshowerheadadjustmentsettings.

4. TurnshowerOn/OffknobtoOffpositionwhenfinished.

Filling the Tub

1. Closethedrain.

2. TurntubfillOn/OffvalvetoOnpositionbyrotatingknob.

3. Adjustwatertemperaturewhilewatchingthermometer.

4. TurntubfillOn/OffvalvetoOffpositionwhenwaterreachesdesiredlev el.

NOTE:If hydr omassageuseisanticipated,waterlevelMUSTbecompletelyabovewhirlpooljets.

NOTE:Befor estartinghydr omassage,openthewhirlpool inletandwhir lpooljets.

Using Hydromassage

CAUTION

Before starting hydromassage, water level MUST be completely above whirlpool jets

otherwise damage to the motor/pump will result.

1. Openthewhirlpoolin letbypushinginonthepluginthewhirlpoolinletfitting.

2. Openallwhirlpooljetsbyperformingoneofthefollowing:

•Turnthecenterofthejetcounter‐clockwisetoafullstop.

•Pullthecenterof thejetout.

3. AddInv acareDefoamertobathwater .Re ferto

De foamerbottlefordirections.

4. PushwhirlpoolOn/Offbuttontostart whirlpooljets.

5. Adjustthewhirlpoolaeratorforde siredwateragitationbyrotatingthe knob.

6. Afteruse,pushwhirlpoolOn/Offbuttontostopwhirlpooljets.

7. Drainthetub.

Stream

Shower Spray

Mixture of Spray and Pulse Massage

Pulse Massage

previous next