Filter
Top Products
76 Automower from
9. Trouble shooting
™
Outside working area If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence,
reinforcement bar) or buried cables in
the vicinity.
Try moving the boundary wire.
The working area slopes too much. Check that the boundary wire has
been routed correctly.
The boundary wire has been routed
the wrong way around an “island”.
Check that the boundary wire has
been routed in accordance with the
installation instructions.
The boundary wire is too close to the
edge of the working area.
Check that the boundary wire has
been routed correctly.
Low battery voltage Automower cannot find the charging
station.
Change the search settings
according to the
Follow loop in (3-2-2)
on page 55.
Change the position of the charging
station.
The battery is spent. Expected life is 1 - 3 years. Contact
your dealer to replace the battery.
Wrong PIN code Wrong PIN code has been entered.
Three attempts are permitted, the
keypad is then blocked for five
minutes.
Enter the correct PIN code.
No drive Automower has got caught in
something.
Free the mower and rectify the
reason for the lack of drive. If it is due
to wet grass, wait until the lawn has
dried before using the mower.
No contact in charging
station
The Automower makes poor contact
with the contact strips in the charging
station.
Check that the Automower has
docked correctly in the charging
station.
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and the Automower has made a
number of charging attempts.
Place the Automower in the charging
station and check that the charging
strips and contact strips make good
contact.
An object is obstructing the
Automower.
Remove the object.
Stuck in charging
station
An object is preventing the
Automower from reversing out of the
charging station.
Remove the object.
Upside down The Automower leans too much or
has turned over.
Turn the mower the right way up.
Needs manual
charging
The Automower is set in MAN
operating mode.
This behaviour is normal; no action
required.
Fault message Cause Action