Filter
Top Products
Automower from 31
3. Installation
™
Joining the boundary wire
If the boundary wire is not long enough and needs to
be spliced: Use original solderless coupler, part
number 535
13 37-01. It is waterproof and gives a
reliable electrical connection.
To splice: Insert both cable ends in the coupler. Now
press down the button on top of the connector fully.
Use a pair of pliers or the like, as the button on the
connector is difficult to press down by hand.
3.5 Connecting the boundary wire
Connect the boundary wire to the charging station:
1. Lift up the cover on the charging station:
• Grip under the edge of the cover with both
hands and pull straight out towards the sides.
• Now lift the cover straight up.
IMPORTANT INFORMATION
Twisted cables, or a screw terminal
(chock-block), insulated with insulation tape
is not a satisfactory splice. Soil moisture will
cause the conductors to oxidise and after a
while result in a broken circuit.
3012-535
3012-536
3012-268
3012-269