Filter
Top Products
Automower from 37
3. Installation
™
7. Route the guide wire at least 2 metres straight
out from the front edge of the charging plate.
If you shall install the guide wire through a passage:
• Automower follows the guide wire on the same
side of the wire both to and from the charging
station. This means that in towards the charging
station the guide wire is on the right side of the
mower and away from the charging station the
guide wire is on the left side of the mower.
In the passage, the guide wire must be placed so
that the mower has as much space to run as
possible. The distance between the boundary
wire and the guide wire must however be at least
30
cm (see the picture above).
The same minimum distance (30 cm) also
applies between the guide wire and the guide
wire in the passage,
8. Run the guide wire to the spot on the boundary
wire where you want to make the connection.
9. Lift out the boundary wire.
10. Cut off the boundary wire using a pair of wire
cutters.
3012-648
Maximum
distance
At least 30 cm
At least
2 m
3012-649