Filter
Top Products
42 – English
LUBRICATION
Lubricating the belt adjuster
The belt adjuster should be lubricated regularly
using good quality molybdenum disulphide
grease*.
1 nipple from the right-hand side under the engine’s
lower belt pulley, until grease is forced out.
With daily use lubrication should be conducted
twice a week.
General lubrication
All joints and bearings are lubricated on
manufacture with molybdenum sulphide grease.
Re-grease with same type of grease*. Lubricate the
steering and control wires with engine oil.
The machine should be lubricated regularly, and
twice a week when used daily.
Check the transmission’s oil level
1. Remove the transmission cover. Loosen both
screws (one on each side) and lift off the
transmission cover.
2. Check that there is oil in the transmission’s oil
tank. Fill if necessary with engine oil
SAE 10W/30 (class SF–CC).
6008-039H
6008-240H
6008-232
* Grease from well-known brand names (petrol
companies, etc.) usually maintains a good quality.
The most important property is that the grease
provides good protection against corrosion.
8009-466
Change of oil filter
Replace oil filter every 200 operating hours. Drain
oil first using the plug on the filter base. Remove
the old filter using an oil filter tool. Lightly coat
rubber gasket with new oil, then install filter by
turning it to the right until hand tight. Tighten the
filter an additional 1/2 turn. Check that the drain
plug is reinstalled before starting the engine.
Start engine and check for leakage.