Filter
Top Products
30 – English
MAINTENANCE
Check the engine’s cooling air intake
Clean the air intake grille in the engine cover
behind the driver’s seat.
Fold open the engine cover.
Check that the cooling intake is free from leaves,
grass and dirt.
Check the air duct, located on the inside of the
engine cover, ensure it is clean and does not rub
against the cooling air intake.
If the cooling intake is blocked this will interfere with
the cooling of the engine, which can damage the
engine.
Checking the tyre pressure
The tyre pressure should be 60 kPa
(0.6 kp/cm
2
/8.5 PSI) all round.
To improve driving, the pressure on the rear tyres
can be reduced to 40 kPa (0.4 kp/cm
2
/5.6 PSI).
The maximum tyre pressure is 100 kPa
(1.0 kp/cm
2
/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres
will result in the blades cutting the grass
at different heights.
Main fuse
The fuse is located in a loose holder under the
battery case cover, in front of the battery.
Type: Flat-blade U-link, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse indicates that the U-link has burnt off.
Pull the fuse out of the holder when replacing.
The fuse is used to protect the electrical system. If
it blows again shortly after replacing this is due to a
short circuit, which must be rectified before the
machine is used again.
WARNING!
The cooling air intake rotates
when the engine is running. Mind
your fingers.
RIDER 850
RIDER 850
6008-030
8009-470
8009-370
8009-431
Air intake grille
Cooling air intake