Filter
Top Products
English – 41
LUBRICATION
Changing the oil
The oil should be changed for the first time after
5 hours of running time. Thereafter, it should be
changed every 100 hours of running time.
With heavy loads or high temperatures replace the
oil after every 50 hours.
WARNING!
Engine oil can be very hot if it is
drained off directly after the
engine is stopped. Therefore
allow the engine to cool down
first.
IMPORTANT INFORMATION
Used engine oil and oil filters are
hazardous to health and environment and
must in accordance with the law not be
poured out on the ground or in the nature,
and must be handed in to a workshop or
other designated station for treatment.
Avoid skin contact, wash with soap and
water in the event of spillage.
Check the engine’s oil level
Check the oil level in the engine when the Rider
stands horizontal with the engine switched off.
Fold open the engine cover.
Release the dip stick and pull out. Wipe off the oil
and insert again.
The dip stick must not be screwed down.
Now release the dip stick again and pull out. Check
the oil level.
The oil level should lie between the markings on dip
stick. If the level approaches the “ADD” mark, top
up with oil to the “FULL” mark.
The oil is filled in the same hole for the dip stick.
Fill the oil slowly. Tighten the dipstick correctly
before starting the engine. Start and run the engine
at idling speed for approx. 30 seconds. Turn off the
engine. Wait 30 seconds and check oil level. If
necessary fill so that the oil comes up to the “FULL”
mark on the dipstick.
Use engine oil class SG or SH, 10W/30 above
freezing point or 5W/30 below freezing point.
Do not mix different types of oil.
1. Place a receptacle under the engine oil drain
plugs (A), located on the right-hand side of the
engine.
2. Remove the dip stick and two drain plugs (A).
3. Let the oil run out into the receptacle.
4. Fit the drain plugs and tighten.
5. Fill up with oil to the “FULL” mark on the dip
stick. The oil is filled in the same hole for the dip
stick.
See “Check the engine’s oil level” above for
filling instructions. The engine holds 1.9 litres
(1.8 USqt) of oil.
6. Run the engine warm and then check that there
is no leakage from the drain plugs.
8009-471
8009-464
8009-465