Filter
Top Products
28 – English
WARNING!
Procedures on contact with acid
External: Rinse well with plenty of water.
Internal: Drink large quantities of water or
milk. Contact a doctor as soon as
possible.
Eyes: Rinse well with plenty of water.
Contact a doctor as soon as
possible.
Batteries emit explosive gas. Sparks, flames
and cigarettes must absolutely not be
brought into the vicinity of the battery.
Battery
The battery is maintenance free. Check cables and
connections for abrasion and oxidation.
MAINTENANCE
Ignition system
The engine is equipped with an electronic ignition
system. Only the spark plug requires maintenance.
For recommended spark plug, see chapter
“Technical data”.
IMPORTANT INFORMATION
Fitting the wrong spark plug type can
damage the engine.
1. Remove the ignition cable shoe and clean
around the spark plug.
2. Remove the spark plug with a 5/8" (16 mm)
spark plug socket wrench.
3. Check the spark plug. Replace the spark plug if
the electrodes are burned or if the insulation is
cracked or damaged. Clean the spark plug with
a steel brush if it is to be reused.
4. Measure the electrode gap with a gapping tool.
The gap should be 1.02 mm/0.040". Adjust as
necessary by bending the side electrode.
5. Reinsert the spark plug, turning by hand to
avoid damaging the threads.
6. After the spark plug is seated, tighten it with
38-43 Nm (28-32 lbft).
7. Replace the ignition cable shoe.
IMPORTANT INFORMATION
Inadequately tightened spark plugs can
cause overheating and damage the engine.
Tightening the spark plug too much can
damage the threads in the cylinder head.
8009-468
1
2
3
4
1. Wire gauge
2. Spark plug
3. Side electrode
4. Gap