Filter
Top Products
English - 67
9. TROUBLE SHOOTING
Outside working area If this occurs in isolated areas it may
be due to interference from metallic
objects (perimeter fence,
reinforcement bar) or buried cables in
the vicinity.
Try moving the boundary wire.
The working area slopes too much. Check that the boundary wire has
been routed correctly.
The boundary wire has been routed
the wrong way around an island.
Check that the boundary wire has
been routed in accordance with the
installation instructions.
The boundary wire is too close to the
edge of the working area.
Check that the boundary wire has
been routed correctly.
Low battery voltage Automower
®
cannot find the charging
station.
Change the search settings
according to the Follow loop in (3-2-2)
on page 47.
Change the position of the charging
station.
The battery is spent. Expected life is 1 - 4 years. Contact
your dealer to replace the battery.
Wrong PIN code Wrong PIN code has been entered.
Three attempts are permitted, the
keypad is then blocked for five
minutes.
Enter the correct PIN code.
No drive Automower
®
has got caught in
something.
Free the mower and rectify the
reason for the lack of drive. If it is due
to wet grass, wait until the lawn has
dried before using the mower.
No contact in charging
station
Automower
®
makes poor contact with
the contact strips in the charging
station.
Check that Automower
®
has docked
correctly in the charging station.
Charging station
blocked
The contact between the charging
strips and contact strips may be poor
and Automower
®
has made a number
of charging attempts.
Place Automower
®
in the charging
station and check that the charging
strips and contact strips make good
contact.
An object is obstructing Automower
®
. Remove the object.
Stuck in charging
station
An object is preventing Automower
®
from reversing out of the charging
station.
Remove the object.
Upside down Automower
®
leans too much or has
turned over.
Turn the mower the right way up.
Needs manual
charging
Automower
®
is set in MAN operating
mode.
This behaviour is normal; no action
required.
Check ultrasonic Rubbish, dust or suchlike has blocked
the ultrasonic sensor.
Clean the two ultrasonic sensors on
the mower’s body.
Automower
®
has repeatedly crashed
at too high a speed.
Place boundary wire around
obstacles that are not being detected
by the ultrasonic.
Fault message Cause Action