Filter
Top Products
English - 19
3. INSTALLATION
3.3 Charging the battery
Automower
®
is supplied with an uncharged battery. As
soon as the charging station is connected, it is possible
to charge the mower.
1. Set the main switch to the OFF position.
2. Place Automower
®
in the charging station to
charge the battery while you are laying the
boundary wire.
From an uncharged state the battery takes about
1 1/2 to 2 1/2 hours until it is fully charged.
3.4 Installation of the boundary wire
The boundary wire can be installed in one of the
following ways:
• Securing the wire to the ground with staples.
It is preferable to staple down the boundary cable,
if you want to make adjustments to the boundary
wire during the first few weeks of operation.
• Bury the wire.
It is preferable to bury the boundary wire if you
want to dethatch or aerate the lawn.
If necessary both methods can be combined so one
part of the boundary wire is stapled down and the
remainder is buried.
IMPORTANT INFORMATION
Do not tread or walk on the charging station
plate.
IMPORTANT INFORMATION
Automower
®
cannot be used before the
installation is complete.