Filter
Top Products
25
41462-01 10/14/2005
®
Noisy operation. 1. Blade iron screwed loosely to motor.
2. Blade screwed loosely to blade
iron.
3. Blade cracked.
4. Using non-approved speed control.
5. Optional Light Kit is not properly
installed.
6. Switch housing is loose.
1. Tighten screws until snug.
2. Tighten screws until snug.
3. Replace all blades.
4. Change to approved speed control.
5. Refer to the Optional Light Kit in-
stallation instructions.
6. Check and tighten screws to the
switch housing mounting plate
and to the upper and lower switch
housing.
PROBLEMPROBLEM
PROBLEMPROBLEM
PROBLEM
PROBABLE CAUSEPROBABLE CAUSE
PROBABLE CAUSEPROBABLE CAUSE
PROBABLE CAUSE
SOLUTIONSOLUTION
SOLUTIONSOLUTION
SOLUTION
Excessive wobbling.
Note:Note:
Note:Note:
Note: When switching from medium
to low speed, you may notice some fan
wobble. When the fan stabilizes at low
speed, wobble will disappear.
1. Unbalanced blades.
2. Loose blades or blade iron.
3. Fan not secure on hanger assem-
bly.
4. Fan hanger ball not seated in
canopy tabs.
1. Use balancing kit included with fan.
2. Tighten all screws.
3. Turn power off, support fan very
carefully, loosen canopy and hang
correctly.
4. Turn power off, support the fan
very carefully, and check that the
hanger ball is properly seated.