Filter
Top Products
21
41462-01 10/14/2005
®
off and on, the user is encouraged
to try to correct the interference by
one or more of the following mea-
sures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is con-
nected.
• Consult the dealer or an experi-
enced radio/TV technician for help.
Note:Note:
Note:Note:
Note: Any changes or modifica-
tions to the transmitter or receiver
not expressly approved by Hunter
Fan Company may void one’s au-
thority to operate this remote con-
trol.
3. For use only with electrically re-
versible ceiling fans rated at 1.0
amp or less, and fan incandescent
light kits rated at 300 watts or less.
4. Not for use with shaded-pole or
nonreversible motors. Not recom-
mended for use with the Hunter
Original ®.
FCC INFORMA FCC INFORMA
FCC INFORMA FCC INFORMA
FCC INFORMA
TIONTION
TIONTION
TION
1. This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device
must accept any interference re-
ceived, including interference that
may cause undesired operation.
2. This equipment has been tested
and found to comply with the lim-
its for a Class B digital device, pur-
suant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against
harmful interference in a residen-
tial installation. This equipment
generates, uses and can radiate ra-
dio frequency energy and, if not in-
stalled and used in accordance with
the instructions, may cause harm-
ful interference to radio communi-
cations. However, there is no guar-
antee that interference will not oc-
cur in a particular installation.
If this equipment does cause harm-
ful interference to radio or televi-
sion reception, which can be deter-
mined by turning the equipment
LIGHT CONTROLLIGHT CONTROL
LIGHT CONTROLLIGHT CONTROL
LIGHT CONTROL
Turn the light on or off indepen-
dently from the fan by pressing the
LIGHT button. When the light is on,
press the LIGHT button 1 time for
a gradual off (light dims from full
brightness to completely off) or
press the LIGHT button 2 times for
an instant off.
Press the button for longer than 1
second, it becomes a dimmer. The
light varies from ‘bright’ to ‘dim’
over approximately 8 seconds. This
sequence will reverse the light
when it reaches the brightest or
dimmest level if you continue to
hold the LIGHT button. Release the
button when the desired level is
reached.
AUTO RESUMEAUTO RESUME
AUTO RESUMEAUTO RESUME
AUTO RESUME
Quick (pressing less than 1 second)
on/off operation of the LIGHT but-
ton maintains the desired bright-
ness level set previously.