Filter
Top Products
26
41457-01 7/2000
®
STEP 11 - INSTALLING LIGHT FIXTURE
Your fan may include a light fixture.
Information for wiring and installing
all included Hunter light fixtures fol-
lows.
Note: If you purchased a fan with-
out a light fixture, you may purchase
an accessory light kit separately. For
best performance and beauty, use
only Hunter-brand light kits, Type A-
Z. Hunter light kits are designed,
tested, and UL approved for all
Hunter fans, and are available at
most Hunter dealers. To install the
light kit, follow the instructions in-
cluded with the kit.
If you are not installing a light fix-
ture, turn to OPERATING YOUR
HUNTER FAN for additional instruc-
tions.
WARNING
• To avoid possible electrical
shock, before installing
light fixtures, disconnect
power by turning off the
circuit breakers both to the
outlet box and to its asso-
ciated wall switch location.
If you cannot lock the cir-
cuit breakers in the off po-
sition, securely fasten a
prominent warning device,
such as a tag, to the service
panel.
• Connect house wiring to
the fan before attaching
the light fixture to the fan.
• All wiring must be in accor-
dance with national and lo-
cal electrical codes and
ANSI/NFPA 70. If you are
unfamiliar with wiring, you
should use a qualified elec-
trician.
INSTALLING INCLUDED ACCES-
SORY LIGHT KIT
1. Remove the plug and switch
housing caps from the lower
switch housing. Refer to Figure
11a.
Note: Do not discard the caps.
You will need this if you remove
the light fixture in the future.
2. Locate the white wire and the
black wire coming from the light
fixture.
3. Thread the two wires from the
light fixture through the center
hole in the lower switch housing.
Be sure to thread the black wire
with the larger connector head
through first and then thread the
white wire with the smaller con-
nector head through.