Filter
Top Products
18
41457-01 7/2000
®
CAUTION
Be sure no bare wire or wire
strands are visible after mak-
ing connections.
STEP 7 - WIRING THE FAN
1. You can use either one or two
wall switches to control the fan
and/or lights separately. Use con-
nection 1 on page 19 to
• control the light with a wall
switch and the fan with a
chain pull (one wall switch re-
quired)
• control the light with a chain
pull and the fan with a wall
switch (one wall switch re-
quired)
• control the light with one wall
switch and the fan with an-
other (two wall switches re-
quired)
Use connection 2 on page 19 if
there is no separate wall switch
power wire for the light fixture.
Note: Wall switches not included.
continued
2. Connect the wires as shown in
Figure 7a. To connect the wires,
place the bare metal leads to-
gether. Place a wire nut over the
intertwined length of wire and
twist clockwise until tight as
shown.
3. Separate the connected wires by
placing the green and white wires
on one side of the outlet box and
the black and the black/white
wires on the other side of the
outlet box.
4. Turn the connectors upward. Push
the wires gently into the outlet
box.