Filter
Top Products
15
41457-01 7/2000
®
STEP 6 - INSTALLING THE REMOTE
Remote Model #: UC7067RC
Ratings: 120 VAC, 60 Hz, 1.0 Amp Fan
250 Watts incandescent light
• To avoid possible electrical
shock, before installing the
remote, be sure that all
power is disconnected by
turning off the circuit
breakers to the outlet box.
• All wiring must be per-
formed in accordance with
national and local electrical
codes. If you are unfamil-
iar with the wiring codes,
you should use a qualified
electrician.
• To avoid overheating and
possible damage to other
equipment, do not install
to control a receptacle,
WARNINGS
Note: This device complies
with Part 15 of the FCC
Rules. Operation is subject
to the following two condi-
tions: (1) this device may not
cause harmful interference,
and (2) this device must ac-
cept any interference re-
ceived, including interfer-
ence that may cause undes-
ired operation.
SETTING UP THE TRANSMITTER
1. Remove the battery cover from
the transmitter by pressing down
on the arrow and sliding the cover
off. Refer to Figure 6a.
continued
fluorescent light fixture,
motor operated appliance,
or transformer-supplied
appliance. Use only to con-
trol one paddle-blade ceil-
ing fan and incandescent
light fixture.
Figure 6a - Setting the Code on the
Transmitter
Dip Switches
9 Volt Battery
Battery Cover