Filter
Top Products
3
SAFETY INSTRUCTIONS
TRAINING
1. Read the Instruction Manual carefully. Be thoroughly familiar with the controls and
proper use of the equipment.
2. Never allow children to operate tractor.
3. Keep the area of operation clear of all persons, particularly small children and pets.
PREPARATION
1. Thoroughly inspect the area where the equipment is to be used, remove all foreign
objects.
2. Do not operate equipment when barefoot or wearing open sandals.
3. Check fuel before starting engine. Do not fill gasoline tank indoors, when engine is
running or while engine is still hot. Wipe off any spilled gasoline before starting
engine.
4. Check to be sure PTO is disengaged and put Forward-Reverse and High-Low in
neutral before starting engine.
5. Never attempt to make an adjustment on attachments while engine is running.
6. Operate only in daylight or in good artificial light.
7. Always be sure of your footing; keep a firm hold on the handles and walk; never
run.
OPERATION
1. Do not change engine governor settings to overspeed engine.
2. Do not put hands or feet near or under rotating parts. Keep clear of discharge
openings at all times.
3. Stop mower attachment when crossing gravel drive, walks or roads.
4. If a foreign object is struck, stop engine and thoroughly inspect the attachment and
tractor for any damage, and repair the damage before restarting and operating the
attachment.
5. If the equipment should start to vibrate abnormally, stop the engine and check
immediately for the cause. Vibration is generally a warning of trouble.
6. Stop engine and wait until all moving parts have come to a complete stop before you
leave the equipment.
7. When cleaning, repairing or inspecting, make certain all moving parts have stopped.
Disconnect spark plug wire and keep wire away from plug to prevent accidental
starting.
8. Do not run engine indoors without proper ventilation.
9. Exercise extreme caution when changing direction on slopes. Do not mow
excessively steep slopes.
MAINTENANCE AND STORAGE
1. Keep all nuts, bolts, and screws tight to be sure equipment is in safe working
condition.
2. Never store equipment with gasoline in the tank inside of a building where fumes
may reach an open flame or spark. Allow engine to cool before storing in any
enclosure.
3. Keep engine free of grass, leaves, debris, or excessive grease to prevent overheating
and possible fire hazard.