Filter
Top Products
SERVICE
• Removing and Installing Dual Tailwheel Support
CAUTION: When removing and installing
tailwheel support, it will be necessary to support
the cutter. Before servicing cutter, refer to
PRACTICE SAFE SERVICE PROCEDURES
at the beginning of this section.
1. Remove 1/2” lock nut, washers and 1/2” x 3”
bolt (A).
2. Remove tailwheel support.
3. Install tailwheel support in reverse order.
• Checking Blade Wear
IMPORTANT: Operating with blades that are not alike
will cause vibration. Always replace worn or broken
blades in pairs. Never replace a single blade.
Check blades regularly for wear or breakage.
26 Service
(Service continued from previous page)
(For model RC2084)
• Removing and Installing Single Tailwheel Support
CAUTION: When removing and installing
tailwheel support, it will be necessary to support
the cutter. Before servicing cutter, refer to
PRACTICE SAFE SERVICE PROCEDURES
at the beginning of this section.
1. Remove 1/2” lock nut, washers and 1/2” x 2”
bolt (A).
2. Remove tailwheel support.
3. Install tailwheel support in reverse order.
(For model RC2084)
A
A
Dual Tailwheel
Single Tailwheel