Filter
Top Products
41
7 Digital Communication Interface
Interface Commands
Command Description
Command
Format
†
Command
Example
†
Returned
Returned
Example
Acceptable
Values
Read program set-point soak time pt pt ti: 999 ti: 5
Set program set-point soak time to
n
minutes
pt=
n
pt=5 0 to 500
Read program control mode pc pc prog: {OFF or ON} prog: OFF
Set program control mode: pc=g[o]/s[top]/c[ont]
GO or STOP or
CONT
Start program pc=g[o] pc=g
Stop program pc=s[top] pc=s
Continue program pc=c[ont] pc=c
Read program function pf pf pf: 9 pf: 3
Set program function to
n
pf=
n
pf=2 1to4
Configuration Menu
Operating Parameters Menu
Read high limit hl hl hl:999 hl:126
Set high limit hl=n hl=90 Hot: 25 to
670°C
Cold: 25 to
140°C
Serial Interface Menu
Read serial sample setting sa[mple] sa sa: 999 sa: 1
Set serial sampling setting to
n
seconds
sa[mple]=
n
sa=0 0to999
Read serial duplex mode (cold
side only)
du[plex] du: du:{FULL of HALF} du: FULL
Set serial duplex mode: (cold
side only)
du[plex]=f[ull]/h[alf]
FULL or HALF
Set serial duplex mode to full du[plex]=f[ull] du=f
Set serial duplex mode to half du[plex]=h[alf] du=h
Read serial linefeed mode (cold
side only)
lf[eed] lf lf: ON
Set serial linefeed mode: (cold
side only)
lf[eed]=on/of[f]
ON or OFF
Set serial linefeed mode to on lf[eed]=on lf=on
Set serial linefeed mode to off lf[eed]=of[f] lf=of
Calibration Menu (WARNING – changing the following calibration values may change the accuracy of the instrument.)
Read R0 calibration parameter r[0] r r0: 999.999 r0: 100.578
Set R0 calibration parameter to
n
r[0]=n r=100.324 95.0 to 105.0
Read ALPHA calibration
parameter
al[pha] al al: 9.99999999 al: 0.0038573
Controller Communications Commands continued