Filter
Top Products
S
Save new setting
6.5.2 Set-points
The next parameters are the program set-points.
1 25 First set-point
Use the “UP” or “DOWN” buttons to select any of the set-points.
3 10 Third set-point
Press “SET” to change the set-point.
10.00 Set-point value
Use “UP” and “DOWN” to change the set-point value.
13.50 New set-point value
Press “SET” to save the new set-point value.
The other set-points can also be set in the same manner. Once the set-points are
programmed as desired press “EXIT” to continue.
E
Continue to next menu function
6.5.3 Program Soak Time
The next parameter in the program menu is the soak time. This is the time, in
minutes, for which each of the program set-points is maintained after settling
before proceeding to the next set-point. The duration is counted from the time
the temperature settles to within a specified stability.
Pt=15 Soak time in minutes
Use“UP”or“DOWN”tochangethetime.
Pt=5 New soak time
Press “SET” to continue.
S
Save new setting
6.5.4 Program Function Mode
The next parameter is the program function or cycle mode. There are four pos
-
sible modes which determine whether the program scans up (from set-point 1
25
6 Controller Operation
Ramp and Soak Program Menu