Filter
Top Products
- 13 -
FIG. 7
THIS CLEARANCE SHOULD BE EQUAL
FIG. 6
SHIFTER LEVER
TO TRANSMISSION
FIG. 8
THIS CLEARANCE SHOULD BE EQUAL
3.8.5 Install and adjust wheel drive linkages.
a) Screw threaded end of drive linkages into swivels
in wheel drive idler arms.
b)
Insert clevis pin from bolt bag through drive linkage,
lever and slot in the neutral lock/park brake latches (See
Figure 9). Make proper adjustments before adding hairpins.
FIG. 9
LEVER AND ROD
ADJUSTMENT
c) Adjust drive linkage length by threading into or
out of the swivel until there is a 3/16" to 1/4"
clearance between the linkage assembly and the
bottom of the slot in the neutral lock/park brake
latch (See Figure 10).
Drive Lever
Neutral Lock/Park Brake Latch
Drive Linkage
Clevis Pin