Filter
Top Products
Maintenance
(bushings are located to the inside of the ange
bearings).
Lubricate Motion Control
Bronze Bushings
Service Interval: Every 160 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Unhook seat latch and tilt seat up.
3. Lubricate bronze bushings on ange bearings
securing the motion control arm shafts with a
light oil or a spray type lubricant.
Check Spark Plugs
Service Interval: Every 200 hours
Remove spark plugs, check condition and reset gaps,
or replace with new plugs. See Engine Owner’s
Manual.
Drain Fuel Filter/Water
Separator
Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Place a drain pan under the fuel lter and loosen
the drain plug approximately 1 turn.
3. Water should drain.
4. When fuel begins to ow from the lter, tighten
the drain plug.
Important: Water or other contaminants in fuel
can severely damage fuel pump and/or the other
engine components.
Change Fuel Filter/Water
Separator
Service Interval: Every 400 hours/Yearly
(whichever comes rst)
(more often in dirty or
dusty conditions).
DANGER
Use of improper components can result in system
failure, fuel leakage and possible explosion.
• Ensure that an Authorized Service Dealer
replace the fuel lter and any components for
the fuel system.
• Use only approved fuel lines, hose clamps
and fuel lters for high pressure systems.
Change Inline Fuel Filter
Service Interval: As required
An inline fuel lter is installed between the fuel tank
and the fuel pump. Replace when necessary.
Replacement Filters
Exmark P/N 112-7836
Change Hydraulic System
Filter
Service Interval: After the rst 250 hours
Every 500 hours/Yearly
(whichever comes
rst) thereafter
(Every 250 hours/Yearly if
using Mobil 1 15W50)
Note: Use only Exmark P/N 103-2146.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Raise seat.
3. Carefully clean area around lter. It is important
that no dirt or contamination enter hydraulic
system.
4. Unscrew lter to remove and allow oil to drain
from reservoir.
Important: Before reinstalling new lter, ll
it with Exmark Premium Hydro oil and apply
a thin coat of oil on the surface of the rubber
seal.
Turn lter clockwise until rubber seal contacts the
lter adapter, then tighten the lter an additional
2/3 to 3/4 turn.
5. Fill reservoir as stated in Check Hydraulic Oil
Level section.
36