Filter
Top Products
Operation
and moving the throttle lever to the rear will decrease
engine speed. Moving the throttle forward into the
detent is full throttle.
Brake Lever
Located on left side of unit, just to the front of the
console.
The brake lever engages a parking brake on the drive
wheels.
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the
brake.
The unit must be tied down and brake engaged when
transporting.
Ignition Switch
Located on right fuel tank.
The ignition switch is used to start and stop the
engine. The switch has three positions “OFF”, “ON”
and “START”. Insert key into switch and rotate
clockwise to the “ON” position. Rotate clockwise to
the next position to engage the starter (key must be
held against spring pressure in this position).
Note: Brake must be engaged, motion control levers
out (neutral lock position) and PTO switch “OFF” to
start engine. (It is not necessary for the operator to
be in the seat to start the engine.)
Hour Meter
Located on the right fuel tank.
The hour meter is connected to a pressure switch
installed in the engine block and it records the
number of hours that the engine has run. If the
ignition switch is left on without engine running,
hour meter will not run.
Note: This switch is not a low oil sensor and will not
alert the operator if the engine oil is low.
Fuel Shut-Off Valve
Located directly below the right side of console, next
to the cubby.
The fuel shut-off valve is used to shut off the fuel
when the machine will not be used for a few days,
during transport to and from the jobsite, and when
parked inside a building.
The valve has three positions, each position made
in 1/4 turn increments.
Fuel Flow Valve Handle Position
“Off ” Right
Right Tank
Down
Left Tank Left
Fuel Gauge
Located on the left fuel tank.
The fuel gauge monitors the amount of fuel in the left
tank only. Use the fuel from the right fuel tank rst.
When the right fuel tank is empty, switch to the left
fuel tank. Fuel gauge will monitor the remaining fuel.
Drive Wheel Release Valves
Located on the top right front corner of hydrostatic
pumps.
Drive wheel release valves are used to release the
hydrostatic drive system to allow the machine to be
pushed without the engine running. Unhook seat
latch and tilt seat up to gain access to pumps.
With a 5/8 inch wrench, turn both valves one turn
counterclockwise to release drive system. Turn
clockwise to reset system. Do Not overtighten. Do
Not tow machine.
Tracking Adjustment Knob
Located under the seat on the LH pump control link.
Rotating this knob allows ne tuning adjustments so
that the machine tracks straight with the drive levers
in the full forward position.
Stop machine and wait for all moving parts to stop.
Engage park brake. Unhook seat latch and tilt seat
forward to gain access to the tracking knob. Rotate
the knob clockwise (as viewed from the rear of the
machine) to cause the machine to track more to the
right and counterclockwise to cause the machine
to track more to the left. Adjust in quarter-turn
increments until the machine tracks straight. Check
that the machine does not creep when in neutral with
the park brake disengaged.
Important: Do Not rotate the knob too far, as
this may cause the machine to creep in neutral.
Refer to the Motion Control Linkage Adjustment
section in Maintenance.
21