Filter
Top Products
Dimension One Spas - Aquatic Fitness System - Owner’s Manual
10
Programming the Filter Cycle
The AFS comes with six pre-programmed filter cycles (F1-F6) and two lockout modes (L1 & L2).
Three of the six filter cycles run in Standard Mode and the other three cycles run in Economy Mode.
To enter the programming mode, press and hold both the
WARMER and COOLER buttons at the same time for 3
seconds. The display indicates the filter
mode with a code (F1 indicates Filter
Mode 1, etc.).
Use the WARMER and COOLER buttons
to scroll up or down through the filtering
modes. The filter cycles look as follows:
• Standard Mode: F1, F2, F3
• Economy Mode: F4, F5, F6
• Lockout Mode: L1, L2
Selecting a Filter Cycle
Standard and Economy Mode
In the standard modes your system heats whenever the water temperature drops to 2°F (≅1°C) below
your set temperature, and continues heating until the water is 2°F (≅1°C) above your set temperature.
In Standard Mode, heating the water remains independent of the filter cycles.
In economy mode, the water only heats when the filter runs during a normal filtration cycle.
After entering the filter programming mode press the WARMER (up) button or the COOLER (down)
button until you see F1, F2, F3, F4, F5 or F6.
F1: 2 hours of filtration 2 times a day. (Standard)
F2: 2 hours of filtration 3 times a day. (Standard)
F3: 2 hours of filtration 4 times a day. (Standard)
F4: 2 hours of filtration and heat 2 times a day. (Economy)
F5: 2 hours of filtration and heat 3 times a day. (Economy)
F6: 2 hours of filtration and heat 4 times a day. (Economy)
If you make no further changes for three (3) seconds, the system automatically stores your choice
and exits the programming sequence.
If the display window displays COL or ICE, cool or ice conditions have
been detected. These conditions override economy mode. The system
heats as needed to prevent freezing damage, regardless of the filter
cycle. For more information, see the Troubleshooting Guide (pg. 26).