10-3
10. 3-POINT HITCH AND DRAWBAR
Ex2900 / 3200 Operator's Manual
The drawbar has two adjusting holes that allow the user to
adjust the drawbar length.
Avoid injury:
●Only hitch a towed load to the drawbar to avoid tip-
over. NEVER use the safety chain to tow a load.
■ Maximum Allowable Load on the Drawbar
The drawbar may be overloaded when it is equipped with
a very heavy unit such as a single-axle trailer. Also, the
load exerted onto the drawbar can significantly increase
depending on the tractor travel speed or quality of the
ground. Make sure that the maximum vertical load
working on the drawbar does not exceed 730 lb (330 kg).
■ Adjusting the Drawbar
NOTE:
●If the tractor is equipped with the Mid-Power Take OFF
(PTO), the drawbar cannot move forward to the
“SHORT” position.
The drawbar has two adjusting holes that allow the user to
adjust the drawbar length.
1. Remove the lock ring and pin.
2. Adjust the drawbar to the intended length.
3. Insert the pin and install the lock ring.
(A) Lock ring
(B) Pin
To prevent an accident:
●NEVER tow a load connected to the top link or rear
axle. Otherwise, the tractor can tip over, which can
cause death or serious injury.
NOTE:
●Do not use a floating-type or non-standard drawbar.
2. Drawbar
WARNING
WARNING
P3013704
(A)
(B)
3013736