Cub Cadet EX2900 Lawn Mower User Manual


 
10-1
10. 3-POINT HITCH AND DRAWBAR
Ex2900 / 3200 Operator's Manual
10. 3-POINT HITCH AND DRAWBAR
ALWAYS install an appropriate counterbalance to
the front of the tractor, if necessary, when using a 3-
point hitch-mounted implement.
During transportation, put the 3-point hitch control
lever in its raised position and lock it with the position
stop knob. Do not fully close the hydraulic flow
control / stop knob to hold an implement in the raised
position while the tractor is traveling with the
implements.
Doing so could cause damage to the hydraulic lift
circuit.
ALWAYS use implements designed for a 3-point
hitch. NEVER use unapproved implements with the
3-point hitch. Contact your authorized Cub Cadet
Yanmar dealer for assistance.
(A) Power Take Off (PTO) shield
(B) Lift link (left)
(C) Lower link (left)
(D) Drawbar
(E) Lower link (right)
(F) Sway link
(G)Top link retainer
(H) Lift link (right)
1. Prepare the Implement Being Mounted
NOTE:
The forward-backward length of the drawbar can be
adjusted.
If being too near to the mounted implement, remove the
drawbar.
To prevent an accident, observe the following
instructions:
ALWAYS shut down the engine. Ensure that the
engine has stopped rotating.
Check that no other parts are moving. If any part or
component is still moving, wait until it comes to
complete stop.
Park the tractor safely on flat, solid ground.
After the implement and the 3-point hitch have been
installed, check for possible interference with the
Power Take Off (PTO) shaft and other machine
components. If interference is found, correct it.
WARNING
1. 3-Point Hitch
CAUTION
3013761
(A)
(C)
(D)
(G)
(H)
(F)
(E)
(B)