Filter
Top Products
8
Figure 7
Figure 8
ATTACHING THE BAG
1. Place bag inside of handle assembly. Slip the
opening on the bag over the discharge chute,
making certain it is over the rib on the discharge
chute. See Figure 6.
2. Place the four straps on the top of the bag over
upper handle, hooking them on studs. See
Figure 7. Be sure the bag goes under the drive
clutch handle.
3. Squeeze the clamp on the drawstring, and pull
the drawstring tight. Release the clamp.
INSTALLING THE SHIFT KNOB
Thread the shift knob onto the end of the shift lever.
TAMPER PLUG (IF EQUIPPED)
The handle on the tamper plug must be in the
vertical position as shown in Figure 8. To determine
which side of the tamper plug is up, match the angle
of the tamper plug to the angle of the chipper chute.
Insert the tamper plug into the chipper chute.
NOTE: Tamper plug should remain in the chipper
chute whenever the chipper chute is not in use.
SECTION 6: OPERATION
BEFORE USING YOUR CHIPPER-VACUUM, REFER TO THE ‘‘SAFETY RULES’’ AS SHOWN ON PAGES
2 AND 3 OF THIS MANUAL. ALWAYS BE CAREFUL.
The operation of any chipper-vacuum can result in foreign objects being thrown into the eyes,
which can damage your eyes severely. Always wear the safety glasses provided with this
unit or eye shields before chipping, or while performing any adjustments or repairs.
We recommend Wide Vision Safety Mask for over spectacles or standard glasses.
CONTROLS (See Figure 9)
SHIFT LEVER—The shift lever determines ground
speed of your unit. It may be placed in one of eight
positions. Of these eight, six positions are to go
forward, and two positions are to go in reverse.
Forward—one of six speeds. Position number one
(1) is the slowest. Position number six (6) is the
fastest.
Reverse—two reverse (R) speeds. “R” (all the way
to the right) is the faster of the two.
DRIVE CLUTCH HANDLE
Squeezing the drive clutch handle against the upper
handle engages the wheel drive. Release the drive
clutch handle to stop the wheel drive.
Figure 9
Straps on
Bag
Shift Knob
Straps on
Bag
Upper Handle
Handle
Tamper Plug
Chipper
Chute
Shift Lever
Drive Clutch Handle