Filter
Top Products
7
Figure 4
Figure 5
Figure 6
ATTACHING THE CHIPPER CHUTE AND
SUPPORT BRACKET
(See Figure 4)
1. Remove the two hex bolts, flat washers and nuts
which are attached to the support bracket.
2. Attach the support bracket to the bottom of the
chipper chute loosely using the hardware
removed previously. Heads of the hex bolts and
washers go to the inside of the chipper chute.
3. Remove the two hex lock nuts from the hex bolts
which secure the right side of the upper handle to
the lower handle. Leave bolts and washers in
place.
4. Remove three cupped washers and 5/16" hex
nuts from the weld studs beside the opening on
the right side of the chipper-vacuum.
5. Place the chipper chute in position over the weld
studs (slot goes at the bottom). Secure with
cupped washers and hex nuts just removed.
Only tighten the three nuts one or two threads
for ease of further assembly.
NOTE: Cupped side of the washer goes against
the chipper chute. See Figure 2 to identify cupped
side of washer.
6. Place the support bracket over the two bolts in
the handle. Pushing UP on the chipper chute will
aid the alignment of the holes in the support
bracket with the bolts in the handle.
7. Tighten all hardware securely on the chipper
chute, support bracket and handle.
ATTACHING THE CLUTCH CABLE
The clutch cable has been partially assembled at the
factory. You will have to attach the clutch cable, to
the handle.
1. Loosen the hex nuts at the cable bracket and
back the bottom hex nut all the way down.
2. Holding the drive clutch handle up, hook the “Z”
end of the cable into the drive clutch handle from
the outside to the inside. See Figure 5. Pliers will
aid in assembly.
CLUTCH CABLE ADJUSTMENT
Adjust the hex nuts at the cable bracket so there is
no slack in the cable, but the cable is NOT tight. Do
not overtighten the cable. See Figure 5.
To check the clutch adjustment, proceed as follows.
1. Push the chipper-vacuum backward and forward
with the drive clutch handle released. It should
move freely.
2. If it does not, loosen both hex nuts at the cable
bracket. See Figure 5. Turn bottom nut
clockwise to loosen the cable.
3. Engage the drive clutch handle (hold against
upper handle), and try to push chipper-vacuum
backward and forward. The wheels should lock
up.
4. If the wheels do not lock up, loosen both hex
nuts at the cable bracket. Turn bottom nut
counterclockwise to tighten the cable.
5. Recheck adjustment. Tighten both hex nuts
when correct adjustment is reached.
Support
Bracket
Chipper
Chute
Upper Handle
Hex Bolts, Flat
Washers and Nuts
Hex Nuts
and Cupped
Washers
Hex
Nuts
Lock
Lower
Handle
Hex Nuts
Drive Clutch
Handle
“Z”
End
Discharge
Chute
Rib
Bag
Drive
Clutch Handle
Drawstring