Filter
Top Products
Connect Hose and Water Supply to Pump
NOTE:Removeanddiscardthe shippingcaps from the pump's
high pressureoutlet andwater inletbeforeattachinghoses.
NOTICE
DONOTrun the pump without the water supply connected
and turned on.
Damageto equipmentresultingfrom failuretofollowthis
instructionwillvoidwarranty.
Uncoil high pressure hoseand attach quick connect end
of hoseto baseof spray gun. Pull down on collar of
quick connect, slide onto spray gun and letgo of collar.
Tug on hoseto besure of tight connection.
WARHIHG
The high pressure stream of water that this
_ quipment produces cancut through skin and its
underlyingtissues, leadingto serious injury and
)ossible amputation.
* NEVERconnecthighpressurehoseto spraytip extension.
* Keephighpressurehoseconnectedto pumpandspraygun
whilesystemispressurized.
* Alwaysbecertainspraygun,spraytips andaccessoriesare
correctlyattached.
2. Similarly, attachother end of high pressure hoseto high
pressure outlet (A) on pump. Pull down on collar of
quick connect, slide onto pump and letgo of collar. Pull
on hoseto besure of tight connection.
,
Beforeconnectinggarden hoseto waterinlet, inspect
inlet screen (B). Cleanscreen if it contains debris or have
it replacedif damaged.DONOTrunpressurewasher if
inlet screenis damagedor missing.
4. Runwater through garden hosefor 30 secondsto clean
out any debris. Turn offwater.
IMPORTANT:DONOTsiphon standing water for the water
supply. UseONLYcold water (less than I O0°F).
NOTICE
Using a OneWay Valve(vacuum breakeror checkvalve) at
pump inlet cancause pump or inlet connector damage.
ThereMUSTbeatleasttenfeetof unrestrictedgardenhose
betweenthepressurewasherinletandanydevice,suchasa
vacuumbreakeror checkvalve.
Damageto equipmentresultingfrom failureto followthis
instructionwillvoidwarranty.
5. Connectgarden hose (notto exceed50 feet in length) to
water inlet.Tighten by hand.
WARHIHG
Riskof eyeinjury.
_Spray cansplash back or propel objects.
Alwayswearsafetygoggleswhenusingthis equipmentor in
vicinityof whereequipmentisin use.
Beforestartingthepressurewasher,besureyouarewearing
adequatesafetygoggles.
NEVERsubstitutesafetyglassesfor safetygoggles.
6. Turn ONthe water,press red button (C) on the gun and
squeezethe trigger to purgethe pump system of air and
impurities.
C>
Checklist Before Starting Engine
Reviewthe assembledunit to ensureyou haveperformed all
of the following:
1. Besure to read SafetyRules and How ToUsePressure
Washerbefore using pressurewasher.
2. Makesure handle is in placeand secure.
3. Makesure shipping capwas removed and oil dipstick
was installed in pump.
4. Checkthat oil has beenadded to proper levelin engine
crankcase.
5. Add proper fuelto fuel tank.
6. Checkfor properly attached hoseconnections.
7. Checkto makesure there are no kinks, cuts, or damage
to high pressure hose.
8. Providea proper water supply at an adequateflow.