Filter
Top Products
Yourpressurewasherrequiressomeassemblyandisready
foruseonlyafterit hasbeenproperlyservicedwiththe
recommendedoilandfuel.
5. Verifypump oil dipstick (A) has beeninstalled into pump.
If you haveany problemswith the assembly of your
pressurewasher, pleasecall the pressurewasher helpline
at 1-800-222-3136.
IMPORTANT:Any attempt to run the engine before it has
been servicedwith the recommendedoil will resultin an
engine failure.
Unpack the Pressure Washer
1. Removeeverything from carton exceptpressure washer.
2. Opencarton completely bycutting eachcorner from top
to bottom.
3. Removepressure washer from carton.
Carton Contents
Checkall contents.If anyparts are missingor damaged,call
thepressurewasherhelplineat 1-888-222-3136.
• The main unit
• Handle
• Spraygun
• Highpressure hose
• Nozzleextension with quick connect fitting
• Engineoil
• Parts bag (which includes items listed below)
• Owner's manual
• Registrationcard
• Bagcontaining 5 multi-colored quick connect spray
tips
• HandleFasteningHardwareKit (whichincludes):
• CarriageBolt (2)
• Plastic Knobs (2)
Becomefamiliar with eachpiecebefore assemblingthe
pressure washer. Checkall contents against the illustration
on page5. if any parts are missing or damaged,call the
pressure washer helpline at 1-888-222-3136.
AssembJingYour Pressure Pasher
Your Craftsmanpressure washer will needassembly before
operation:
1. Fill out and send in registration card.
2. Attach handle.
3. Add oil to engine crankcase.
4. Addfuel to fuel tank.
6. Connectpressurehose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextensionto spray gun.
9. Select/attachquick connect spray tip to nozzle
extension.
Attach HandJe
1. Placehandle (B) onto handle supports (C) connectedto
main unit. Makesure holes (D) in handlealign with
holes (D) onhandle supports.
NOTE:it may be necessaryto movethe handlesupports
from sideto side in order to align the handle so it will slide
over the handle supports.
2. Insert carriagebolts (E)through holes from outside of
unit and attach a plastic knob (F) from inside of unit.
Tighten by hand.
3. Insert multi-colored spray tips in spacesprovided in
handle.