Filter
Top Products
3-7
Pre-Start Inspection and Operation
Operating Instructions
Machine Start-up
To start the machine, the operator must:
1. Stand on the operator's platform (Item 1, Figure 3–5).
2. Move the throttle lever (Item 2, Figure 3–5) to about half way between fast and idle engine
speeds.
3. Move the engine choke lever (Item 3, Figure 3–5) to the CHOKE position.
4. Rotate and hold the starter switch (Item 4, Figure 3–5) in the START position until the
engine starts.
Figure 3–5 Operator's Platform, Engine Throttle, Choke and Key Switch
5. As soon as the engine starts, release the starter key. The key will automatically return to the
RUN position.
6. Leave the throttle setting at about the halfway position and allow the engine to idle. This will
begin warming the hydraulic oil.
7. If the engine begins to labor or sputter, move the choke control lever to the normal run
position. It may be necessary to move the choke lever only part way to the normal position
until the engine has warmed up.
8. In cold weather (32º F [0º C]) after about 5 minutes of engine idling, operate all of the main
hydraulic controls to cycle warmed hydraulic oil through the hydraulic lines into the
cylinders and hydraulic motors. Allow the engine to idle for another 5 minutes before
beginning any machine operations.
3
2
1
4
2445