Filter
Top Products
6-7-06 - Fifth Proof
3-1
Section 3 – Pre-Start Inspection and Operation
IMPROPER USE OF THE COMPACT UTILITY LOADER COULD CAUSE SERIOUS
INJURY OR DEATH. BEFORE OPERATING THE WHEEL LOADER, OR
PERFORMING MAINTENANCE, THE OPERATOR MUST READ AND
UNDERSTAND THE ENTIRE OPERATOR'S MANUAL, REVIEW MACHINE
CONTROLS, LOCATE AND REVIEW ALL WARNINGS AND SAFETY PLACARDS
AND RELEVANT OPERATOR SAFETY MATERIALS INCLUDING WRITTEN,
VISUAL, VIDEO OR VERBAL INSTRUCTIONS.
Pre-Start Inspection
It is very important to do a visual inspection of the machine before beginning operation. This
inspection should include:
• Check all decals and warning signs for damage.
• Check engine oil.
• Check and refill gas tanks.
• Check hydraulic lines and hoses for signs of damage or leaks.
• Inspect the machine for any signs of damage or loose fasteners.
• Check fluid levels and any signs of leaking fluids.
• Do all Daily Service Checks.
• Check machine controls to make sure that they automatically return to the neutral position.
NOTE: The following procedures have several additional service checks and adjustments that
will need to be followed if your machine is equipped with a track drive system.
The following information presents details on these inspection points and service checks.
Daily Service Checks
Table 1: Service Cycle Table
Service Cycle - R = Replace ✓ = Check
***
Under very wet, muddy, dusty or dirty working conditions more frequent lubrication may be required.
Activity Daily (10 Hours)
Fuel ✓ and R
Engine Oil ✓ and A
Engine Oil Filter
Air Filter
Fuel Filter
Engine Idle Speed
Spark Plugs
Battery
Hydraulics
- Hydraulic Filter
- Hydraulic Fluid
- Hydraulic Hoses
✓
✓
✓
Grease ✓***
Tires/Tracks ✓
Visual Check for Loose/Missing Fasteners ✓
Battery
DANGER