Filter
Top Products
Page -8- CLARKE TECHNOLOGY Operator's Manual -Encore S20E
Machine Control Panel
Figure 1
Control Handles (See Figure 1, Item "D")
The control handles are located at the rear of the
machine. They are used to guide the machine.
Solution Control Knob (See Figure 1, Item "E")
The solution control knob regulates the flow of chemi-
cal solution to the floor. To increase the flow, turn
knob clockwise. To decrease the flow, turn counter
clockwise.
Vacuum Motor Switch (See Figure 1, Item "F")
To activate vacuum motor, lower squeegee handle.
Handle has two positions. Lowest position is operat-
ing position and the middle position is transport to
clear vacuum hose.
Brush Motor Switch (See Figure 1, Item "G")
To activate brush motor, lower handle. Brush Motor
and solution flow will activate when the traverse
buttons are pushed. To shut brush motor off, raise
handle to top position.
Main Switch (See Figure 1, Item "A")
The main switch turns "ON" the power to the control
panel. "O" is "OFF" and "I" is "ON".
Hour Meter (Optional)
The hour meter indicates the number of hours the
machine has operated. It runs only when the brush
motor is on.
Circuit Breakers
(See Figure 1, Items "B" and "C")
The circuit breakers reset button are located on the
rear cover.
Item B - Brush Motor (10 amp - 115V)
(5 amp - 230V)
Item C - Control Breaker (2.5 A)
If a circuit breaker trips, determine which motor is not
operating and turn the main switch "OFF". Wait five
minutes and push the reset button back in. Turn the
main switch "ON" and try again. An authorized
service person should be contacted if the breaker trips
again.
D
D
E
A
BC
FG