Filter
Top Products
Page -10- CLARKE TECHNOLOGY Operator's Manual -Encore S20E
Figure 5a
Figure 5b
Figure 5c
How To Install The Brush Or Pad Driver
To install the brush or pad driver on the machine,
follow this procedure:
1. Turn the main switch "OFF".
2. Put the brush lever in the "UP" position.
3. Go to the front of the machine.
4. Using a short Phillips screw driver, loosen the
latch screw enough to allow the retainer to be
free of the cover. (See figure 5a, 1)
5. Open the brush motor cover and remove the
brush housing. See figures 5a and 5b.
6. Put a brush or pad driver under the brush hous-
ing. See figure 5c.
7. Align the lugs on the motor with the slots in the
brush gimbal.
8. Pull the brush up and rotate counter clockwise
until gimbal locks.
9. Replace brush housing and close brush motor
cover.
10. Install the brush retainer latch into the brush
motor cover. Tighten the retainer screw.
How To Remove The Brush or Pad Driver
To remove the brush or pad driver from the machine,
follow this procedure:
1. Put the brush lever in the "UP" position.
2. Turn the main switch "OFF".
3. Go to the front of the machine.
4. Open the brush motor cover and remove brush
housing. See figures 5a-5c.
5. Rotate brush clockwise with a quick snapping
action until brush releases.
6. Replace brush housing and close brush motor
cover.
How To Prepare the Machine For Operation
1