Filter
Top Products
Page -6- CLARKE TECHNOLOGY Operator's Manual -Encore S20E
Procedures For Transporting
How to Put the Machine Into a Van or Truck
WARNING: This machine is heavy. Get
assistance before attempting
to transport or move it. Use
two able persons to move the
machine on a ramp or incline.
Always move slowly. Do not
turn the machine on a ramp.
Do not stop and leave the
machine on a ramp or incline.
The loading ramp must be a
minimum of 32" wide.
WARNING: Machines can topple over if
guided over the edges of
stairs or loading docks and
cause injury or damage. Stop
and leave this machine only
on a level surface. When you
stop the machine, put all
switches into their "OFF"
position.
1. Make sure the loading ramp is at least eight (8)
feet long and a minimum of 32" wide, and strong
enough to support the machine.
2. Make sure the ramp is clean and dry.
3. Put the ramp in position.
4. Remove squeegee assembly, brush housing and
brush or pad driver before loading.
5. Align the machine on a level surface five (5) feet
in front of the ramp.
6. Push the machine backwards to the top of the
ramp.
7. Fasten the machine to the vehicle. Clarke
Technology recommends a strap over the top of
the machine and a strap to keep the machine
from rolling forward or backwards. If this is not
done, there is a possibility of the machine
toppling over.