ASSEMBLY
SE6 05/05 Assembly Section 3-9
© 2005 Alamo Group Inc.
ASSEMBLY
CHAIN GUARDS (Optional Equipment at extra cost) (Figures Asm-R-0081
& Asm-R-0082)
CHAIN GUARDS: Front and Rear Chain Guards (Optional Equipment) are recommended for higher than
normal usage (100 hours or more per year) and will provide protection from thrown objects with careful
operation. Chain Guards must be maintained in good repair by replacing missing or worn sections or by being
replaced when seriously worn or damaged.
Front Chain Guards (Figure Asm-R-0081)
1.Attach Chainguard Plate (1) to deck using 5/8" x 1
3/4" Bolts (4), Washers (5), and Locknut (6).
2.Insert the individual Chain Links (2) into slotted
holes in Chain Guard Plate (1) and secure in place
with Rod (3) as shown in Figure Asm-R-0081.
(Complete Chainguard Assemblies are available.
See Parts Section in this book.)
3.Attach the corner plate (7) to the side of the deck
with a 1/2" x 1-1/2" Bolt (8), and Locknut (9). See
Figure Asm-R-0081
Rear Chain Guard - (Figure Asm-R-0082)
1. Attach both Deflectors (1 & 2) to deck using 1/
2" x 1-1/4" Bolts (4) and Locknuts (5). In center
of deck use 1/2" x 4" Bolt (7) and Locknut (5) to
tie both Deflectors (1 & 2) together. See Figure
Asm-R-0082.
2. Secure Chainguard Assembly (3) to Deflectors
(1 & 2) using 1/2" x 1-1/4" Bolts (4),
Flatwashers (6), and Locknuts (5).
3. Fasten Rear Plate (8) on both ends of
Deflectors (1 & 2) using 1/2" x 1-1/4" Bolts (4)
and Locknuts (5). Figure Asm-R-0082.